Shingle roof section

Everything Thanks!" We recommend to start the installation with the shingles on the valley side with the lowest slope or shortest distance to the ridge. However, there may be the odd occasion where a little fix is needed, and, fortunately, asphalt shingles can easily be removed and replaced in just seven steps. Asphalt shingle roofs are really a group of components with the shingles being the most visible part. In order to replace damaged roof shingles, you need to remove the damaged shingle, install the new one, and seal the edges. 2. "Exactly what I needed. It's great that there are people who will post videos like this. Note: Other step flashing sizes are also acceptable.

was explained and demonstrated in a very straightforward manner. This article is not a substitute for proper live training and IKO recommends that only properly trained professional roofing contractors engage in the shingling of roofs.The next time you read the package instructions or Roof planes that butt against vertical walls at the end of the shingle course are protected by metal step flashing at least 125 mm high and 125 mm wide (5″ high and 5″ wide).

Place the second step flashing piece over the end shingle in the first course by positioning it 143 mm (5 5/8″) above the bottom edge of the exposed asphalt shingle.Make sure that the tab of the shingle in the second course will cover it completely. Can I put a nail though the tab above it, without lifting it, and caulk it so that it can’t be seen from the yard?Include your email address to get a message when this question is answered.By using this service, some information may be shared with YouTube.All tip submissions are carefully reviewed before being publishedIn cold weather, avoid excessive bending of the shingles as it could cause crackingIf you are unsure about anything, don't risk your well-being; please consult a roofing professional.In hot weather, cool shingles with a water hose to allow easy separation of the shingle tabs

IKO assumes no responsibility for errors that may appear on this website.IKO strives to accurately reproduce the screen images of the shingle swatches and house photos shown. If a component is not required, insert not applicable (n/a) in the text box.

Can I re-shingle a roof without taking off the old ones? It's code in most places to not have more than two layers of roofing materials. This article from the experts at IKO Roofing will help you make sense of it all by highlighting the basic steps and outlining the fundamental purpose for each roofing system component. Take a stack of regular 3 tab shingles and cut little v notches at the top edge of the shingles between the tabs. Shingle Roof System Miami-Dade County HVHZ Electronic Roof Permit Form Section D Shingle Roof System Roof System Manufacturer: Notice of Acceptance Number: Fill in the specific roof assembly components. I guess whoever installed them overshot the nailing of each row above.

Everything explains why. For instance, when using metal flashing with shingles with a typical 143 mm (5 5/8″) exposure (such as traditional 3-tab shingles), the size of the flashing will be 250 mm x 200 mm (10″ x 8″). "Exactly what I needed. Lots of websites and videos go into great detail on how to shingle a roof. wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors.